Paige, TX

Today I arrived and met with Gary. I completed the fall evaluation today, I verified system performance and that it’s safe during operation. While onsite I flushed and treated condensation removal system, I also washed outdoor unit using water. Indoor unit is dirty and shows signs of bacteria, system is dated 2011 after speaking with customer we are going to let it ride until it’s time to replace. Upon departure left system operating in cooling mode set to 72 currently 71 inside.

Today I arrived and met with Mrs Pat. I completed the fall evaluation of both hvac units. I evaluated performance and safety of both systems, both systems perform well and are safe. I flushed and treated the water removal systems, washed outdoor units with water and treated electrical cabinets with insecticide. Mrs Pat concern of new unit noisy at the fan, I found one of the mounting bolts were a 1/4 turn loose. After correcting this the noise went away. I noticed on unit 2 during evaluation indoor unit was dirty and had bacteria signs. Moving forward customer approved HH14C, we will call to schedule today for the return trip. Upon departure left both systems in cooling mode set to 75 and 74.

Upon my arrival I performed the heating evaluation on the straight electric package unit. Found that everything is operating properly at this time.

Upon my arrival I performed the heating evaluation on the furnace system. Found that everything is operating within manufacture specifications at this time.

Upon my arrival I found that there was a slight amount of water underneath the audible water alarm. I checked the water removal system and verified it was clear and reset the audible water alarm. I moved the alarm closer to the edge of the pan and showed the customer how to turn it off. There were no obvious signs of where the condensation came from. Left the system running.

Today I arrived in Paige and spoke to the customer about adding the upstairs system to the comfort plan however customers denied. We also spoke about concerns, new system has a whine you can hear from the vents during operation. While completing evaluation I flushed and treated indoor water removal system while paying close attention to the noise. The noise is coming from the indoor air movement system, it’s either motor noise or imbalance in the cage, I left a voicemail with tech support and will call customers once I obtain a response. Moving forward I monitored safeties and performance inside and out, also washed the outdoor unit using water. I treated the outdoor electrical panel using electrical insecticide as they had ants within cabinet. All electrical data and performance checks were proper at this time. Upon departure I made customers aware I’d be contacting them directly once I have news from tech support about the motor noise, I also spoke with them about

Upon my arrival in Paige I performed the heating evaluation on the electric heat straight cool system. Found that everything is operating properly at this time. Spoke with the customer about surge protection and the importance of it. He chose to decline at this time due to the price of it.

Today in Paige I met with the homeowners and I completed fall evaluation for her homes hvac system. I evaluated and verified system is performing exactly as designed and it is safe while doing so. Electric heater is proper, indoor is clean and I flushed the water removal system while Onsite today. During outside evaluation I washed the system off using water, and treated electrical panel using electrical insecticide. Upon departure left system in cooling mode set to 75 currently 72 indoors.

Today in Paige I completed the fall evaluation of customers hvac systems. Customer has 2 Mitsubishi condensing units tied to distribution boxes, and multiple indoor sections some ducted and some ductless. All units had clean filters today, I flushed all drains, I modified 3 drains in the guest side adding ball valves and unions for proper isolation and cleaning of the drains. I recommended customer have 2 systems cleaned out today and that was main living room ductless and back office ductless, customer would like to complete those himself. Upon departure left all 8 units cooling, all set to 68-70, aside from the front storage room that is set to 80.

Today in Paige and I evaluated the hvac system today for performance and safety. I began by washing outdoor system using water, I also treated the electrical cabinet with electrical insecticide. I added a union to the pvc water removal system in the attic for cleaning, I flushed the line at this time. I found system operating well and using a good amount of power. Customer re enrolled in the comfort plan at this time.

Today I arrived in Paige and completed the cooling evaluation of the system. I tested indoor and outdoor for performance and safety, I also flushed water removal system, washed outdoor system using water and treated outdoor electrical cabinet with electrical insecticide. Moving forward customer approved the maintenance today of indoor cleaning and outdoor service disconnect, Stephanie to call and schedule return trip. Upon departure I closed customers property gate, left system running schedule on auto at 69 heating, 75 cooling, currently reading 74 indoors.

Upon arrival in Paige I began the cooling evaluation and identified a fault in the voltage enhancement system. The customer mentioned that he believed it had been replaced during a previous repair in March. After reviewing the records, I found no documentation of such a replacement. I discussed repair options with the customer, and he chose to proceed with the HN13E. I replaced the voltage enhancement system, voltage distribution system, and performance enhancement system. Additionally, I re-terminated the wire connections, replaced a section of insulation on the suction line, chemically cleaned the outdoor coil, and installed surge protection for the indoor unit. After testing, the system was operating properly. I provided a small discount as the customer opted for a higher-tier repair.

Upon my arrival in Bastrop I performed a HL1B heat transfer media replacement on the indoor air handler. Recovered and disposed of old refrigerant, replaced failed part. Pressure tested and performed vacuum. Recharged system with new refrigerant. And checked operations after, system is now working properly.

Today I arrived in Paige and met with Mr. & Mrs. Harrison, we spoke briefly about a few concerns regarding the thermostat, and most importantly a switch that cuts off system, as well as the light switch in attic that controls both the light bulb and to the furnace. With customers approval today I installed a new ecobee thermostat and connected to WiFi, I installed a service disconnect for the furnace that way the light switch is solely for the light in attic and installed voltage protection system. I also went through and made new electrical connections within furnace control board for communication, and verified all electrical within outdoor unit. Prior to departure Mr. Harrison had to leave so I went over the new ecobee functions with Mrs. Harrison, system is on and cooling at this time.

Today I met with Mr.Benning's in Paige and verified his concern. Outdoor system doesn’t shut off when thermostat satisfies. I found the voltage distribution device to be shorted closed across the contacts. I verified system starting power and the run capacitor. I spoke with Mr Bennings and after approval I completed repair same day. I installed new voltage enhancement, distribution, and enhancement system. I also replaced all of the connectors within cabinet. Prior to departure we verified repair and system starts and stops accordingly now, and the starting power has dropped significantly.

Today I arrived in Paige and met with Alvin and his wife. Concerns of upstairs attic system condensation build up within emergency drain pan. Also that the indoor air circulation system sounds a bit louder. I evaluated concerns and found the primary drain clogged, and air circulation housing filthy. With approval I removed the air circulation system and cleaned it outside, I also flushed the drain and treated pan. At customers request I cut the 90 out before the p trap and placed a T for easier treatment of the trap. Customers system is back on cooling and draining at this time.

Today I completed the cooling evaluation In Paige. While completing evaluation I flushed the water removal system and treated it, I washed outdoor exhaust removal system, and I treated the outdoor electrical panel using JS685. Moving forward we had concerns of bacteria growth in indoor unit as well as the air movement system being dirty. Customer has multiple pets in the home and mentioned they haven’t had the unit cleaned prior, they are definitely interested in taking care of it all with the HH13E, we emailed them the finance app for them to fill out at their convenience. Please email estimates over with pricing.

Upon my arrival in Paige I performed a cooling evaluation found the carrier system is working good at this time. But did find a bad voltage enhancement system on the American standard system. Gave customer options she chose HN13E for this repair. Replaced parts and check operations found that system is working good at this time. WO-TNFR352540

WO-TNFR352317 Upon my arrival in Paige I found that system has a leak on the heat transfer media on the indoor air handler gave customer repair options they choose HL1B

Upon my arrival in Paige I found that the voltage enhancement system was not working, gave customer options he choose to do HN13A , replaced part and checked operations found that system is now working properly. Area was over 90 degrees and will take time to cool back off. WO-TNFR351266

Upon my arrival in Paige I found that the voltage enhancement system was not working , gave customer options he choose to do HN13A , replaced part and checked operations found that system is now working properly. Area was over 90 degrees and will take time to cool back off. WO-TNFR351266

Upon my arrival performed a cooling evaluation in Paige I found that the system is working good at this time. Did talk to customer about replacing the Reme Halo that is not working. They choose to wait. But did renew

Performed the cooling evaluation in Paige and found the system was low on refrigerant. System has a leak at the indoor heat transfer media coil. Spoke with the son about recommendations on replacing over repair due to the age and quality of the equipment. He would like a comfort specialist to come out and quote a new system and would also like to view the repair quotes.

Air conditioning maintenance. Upon my arrival in Paige I found that the fan speed was on low speedset the fan speed to high and and clean the out door condenser, rechecked the pressure and system and found that it is now working a little better and is delivering more air inside the house. Called Daryl before doing and adjustments and said no charge.

Upon my arrival in Paige I found that system was low on refrigerant, added back 2 pound , before doing further work, looked up distributor for this brand in the area and they is none, part are not available for this unit here. We will not be able to do any further repairs on heat transfer media coil that is leaking. Would recommend customer consider replacing system with a new system. They are going to wait until the system needs refrigerant again.